How To Change Hydraulic Fluid In Scag Freedom Z

background image

Section 7

HYDRAULIC SYSTEM

seven.2

A. CHECKING HYDRAULIC OIL LEvEL

The hydraulic oil level should be checked after the showtime 10
hours of operation. Thereafter, check the oil later on every
200 hours of machine operation or monthly, whichever
occurs first.

- Of import -

If the oil level is consistently low, check for leaks
and right immediately.

Wipe dirt and contaminants from around the

reservoir cap. Remove the cap from the hydraulic oil
reservoir.

When the car is "cold" (before operation),

visually check the level of the hydraulic system oil.
Hydraulic system oil level should be in the middle of
the indicator window located on the left side of the
automobile. See Figure 7-2. Exercise NOT overfill; (overfilling
the oil reservoir may crusade oil seepage).

Clean the fill cap and install it onto the reservoir.

HYDRAULIC Organisation

OIL LEVEL

Hydraulic Organization oil Level

Figure 7-2.

B. CHANGING HYDRAULIC OIL

The hydraulic system oil should be inverse later on the first
120 hours of motorcar performance and every 400 hours or
annually thereafter, whichever occurs first. The oil should
likewise be changed if the color of the fluid has become blackness
or milky. A black color and/or a rancid odor usually indicates
possible overheating of the oil, and a milky colour ordinarily
indicates h2o in the hydraulic oil.

- IMPoRtANt -

The hydraulic organisation oil should be inverse if you
notice the presence of water or a rancid odor to
the hydraulic oil.

Park the mower on a level surface and end the

engine.

Remove the three 1/4" filter guard screws and filter

two.

guard from both axles. See Figure 7-3. Clean any
loose droppings around the perimeter of the filter.

REMOVE SCREWS AND

OIL FILTER GAURD

REMOVE OIL

FILTER

Hydraulic oil Filter and Drain Plug

Figure vii-iii.

Place a suitable container under the hydraulic oil

iii.

filters. Remove the cover from the left side tank to
gain access to the hydraulic expansion reservoir.
Remove the make full cap from the reservoir.

Remove the hydraulic filters from both axles and

allow the fluid to drain into the container. Properly
discard the oil when the system has tuckered
completely. See Figure 7-3.

Once the hydraulic system has drained, install new

hydraulic oil filters to both axles by paw, turn 3/4
to one complete turn after filter gasket contacts the
filter base.

Reinstall the filter guards and torque the screws to

65 in/lbs.

Source: https://www.manualsdir.com/manuals/155056/scag-power-equipment-freedom-z-sfz48-26bs-freedom-z-sfz36-20bs-freedom-z-sfz48-19ka-freedom-z-sfz52-26bs-freedom-z-sfz36-17ka-freedom-z-sfz52-19ka-freedom-z-sfz61-28bs.html?page=32

Posted by: richardsonreepris1964.blogspot.com